Yaakov Kranz starting a plane

dr. fancy Oh again x2 our little but nice 172s be explained good actually we did all the pre-flight and now we're going to get going into the plane and we're going to start it up for you okay see you inside ok now we're inside the plane and I have over here a what's called an eboard strapped to my knee and have a I make myself a checklist to make sure we go through all the things and we have gone through a lot of them but now we're going to start the plane for you so there's a whole procedure for that first this passage your briefing and seat belts well my only passenger is the one who's taking it and he's a pilot too but I'm just going to start the engine right now we're going to make sure the circuit breakers are in these are the circuit breakers over here electrical equipment off this is the master switch it's a double switch and the annex is off fuel selector which is down here you have left right and both were on both because this way the two tanks and the wings feed feed simultaneously fuel shut valve of is pushed in its full pushed in now throttle we're going to open it a quarter of an inch this is a throttle mixture idle pulled out oil filter lots standby switch we're going to test put in the test and hold it there with for about 20 seconds to make sure that green light is on that's just make sure that we have enough standby power and that's pretty good now we're going to arm it push it up and we're going to see this PFD or primary flight display comes on and it is initializing and there we go it's starting to come on then you want to make sure that is no red x's well yeah that's because of the calm but right now there's okay the radius are not working we don't have on the engine page in the case which is the left side there are no red x's bus evolt 24 volts minimum and that we have 24.4 and bus faults 1.5 volts or less and we have less okay battery SMS verified discharge minus and the shore is send by a battery annunciators should be shown and it is shown right right there now we're going to call prop clear prompt clear I'm going to put the master switch on that's by the way the prop clay is to let and you really should visually look that any that no one is around the propeller which is a very lethal weapon if used improperly okay master switch on okay beacon light switch on it is on already that's down here now we're going to prime this we're going to pull put the fuel pump on let's fuel pump on put make you rich in for a couple of seconds that and put it off okay fuel pump us off okay go to the next of my checklist I'm gonna start the engine do we have the keys in here in keys are in there and once we start and the engine catches we push the mixture fuel mixture which is this working in so i'm going to hold the brakes i'm going to actually close my door first um and here we go that's it physicians narrator there hey they walk now just